Supermicro SSE-X24S User Manual download pdf (Page 81)

5-29

Chapter 5: Web Based Management Utility

IP Extended ACL

Clicking the IP EXTENDED ACL tab brings up the IP EXTENDED ACL CONFIGURATION page

(Figure 5-24), which displays the various parameters required to configure the Extended

IP access lists. The parameters for this page are shown in Table 5-12.

Figure 5-24. IP Extended ACL Page

Table 5-12. IP Extended ACL Configuration Page Parameters

Parameter Description

ACL Number

This specifies the unique ID for the access list. The valid range is between 1 to

65535. The factory default is blank.

Subnet Mask This specifies the Address Mask corresponding to the IP Address.

Action

This specifies the action to be taken for the access list. The factory default is

Permit.

• Permit: Forwards packets which meet the ACL criteria.

• Deny: Drops packets which meet the ACL criteria.

• Redirect: Forces packets which meet the ACL criteria to specified port.

Source and

Destination IP

Address

This parameter specifies the IP Address for which the access list must be

applied.

Ports List (Incoming)

This specifies the incoming physical ports if this ACL has to be port specific (for

example Gi0/1-10 or Gi0/1). The factory default is blank.

Ports List (Outgoing)

This specifies the outgoing physical ports if this ACL has to be port specific (for

example Gi0/1-10 or Gi0/1). The factory default is blank.

Protocol

This chooses the protocol type to be checked in the packet to apply this ACL.

The factory default is icmp.

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 305 306

No comments

Supermicro SSE-X24S User Manual Page 81