Supermicro SSE-X24S User Manual download pdf (Page 40)

1/10 and 10-Gigabit Layer 2/3 Ethernet Switches

3-2

Command Line

Configuring the switch can be done using a command line via telnet or by using the

serial console interface.

Accessing CLI through Telnet

To access the command line via telnet, follow the below steps.

1. Connect a PC to a network that is accessible to the switch.

For example, connect a PC to any of the front panel ports of the switch and make

sure the PC has an IP address on the same subnet as the switch management IP.

2. In the PC, start a telnet client session with the switch management IP (default IP is

192.168.100.102).

This brings up the switch’s command line interface for user login.

3. Enter the default username (ADMIN) and password (ADMIN) to login to the switch.

4. To view the switch configurations use show commands and to configure the switch

type config term to get access to the configuration commands. For help type ? or

help.

Accessing CLI through a Serial Console

To access the command line via a serial console, follow the steps below.

1. Connect a PC serial port to the switch console port.

2. In the PC, open any serial port access applications, such as Hyperterminal or Term

Ter m.

3. Choose the serial port connected with the switch and configure with the following

parameters:

Baudrate = 9600

Data bits = 8

Parity = None

Stop bit = 1

4. This brings up the switch’s command line interface for user login.

5. Enter username and password to login to the switch.

6. To view the switch configurations use show commands and to configure the switch

type config term to get access to the configuration commands. For help type ? or

help.

For further information on the use of the command line interface, see the separate CLI

User’s Guide manual on your enclosed CD-ROM.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 305 306

No comments

Supermicro SSE-X24S User Manual Page 40