1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User’s Manual
5-164
IGMP Snooping Configuration
Clicking the BASIC SETTINGS tab brings up the IGMP SNOOPING CONFIGURATION page
(Figure 5-143), which allows you to configure IGMP snooping parameters. The
parameters for this page are shown in Table 5-116.
Figure 5-143. IGMP Snooping Configuration Page
Table 5-116. IGMP Snooping Configuration Page Parameters
Parameter Description
System Control This parameter Starts or Shutsdown IGS in the switch.
IGMP Snooping
Status
This parameter enables or disables IGMP snooping globally in the switch. To
enable IGS, GMRP status must be Disabled.
Operational Status
This parameter enables or disables IGMP snooping operationally in the switch.
To enable IGS, GMRP status must be Disabled.
Proxy Reporting
This parameter indicates whether the proxy reporting in the IGMP snooping
switch is to be enabled or disabled.
Snooping Mode
This parameter specifies the IGMP snooping multicast forwarding mode, which
can be configured using the Destination IP Address or the Destination MAC
Address.
Report Forwarding
This parameter specifies whether the IGMP reports are forwarded on all ports or
only on router ports.
Retry Count
This parameter specifies the maximum number of group specific queries sent on
a port on the reception of an IGMPv2 leave message.
Query Transmit On
TC
This parameter allows you to enable or disable query transmit when topology
changes.
Comments to this Manuals