A-1
Appendix A
Rack Installation
A-1 Overview
Some Supermicro switches can be equipped with an optional rail kit (CSE-PT52L) to
make it easy to install them in a rack. This manual provides instructions for installing the
CSE-PT52L mounting rails onto a rack and for installing the switch into the mounting
rails. Following these steps in the order given should enable you to have the system
operational within a minimum amount of time.
A-2 Unpacking the System
You should inspect the box the switch was shipped in and note if it was damaged in any
way. If the switch itself shows damage you should file a damage claim with the carrier
who delivered it.
Decide on a suitable location for the rack unit that will hold your switch. It should be
situated in a clean, dust-free area that is well ventilated. Avoid areas where heat,
electrical noise and electromagnetic fields are generated. You will also need it placed
near a grounded power outlet. Be sure to read the Rack, General and Lithium Battery
Precautions in the next section.
A-3 Preparing for Setup
The optional rail kit (CSE-PT52L) ships in a separate box and that box should include
two sets of rail assemblies, two rail mounting brackets and the mounting screws needed
to install the system into the rack. Read this section in its entirety before you begin the
installation procedure outlined in the sections that follow.
Choosing a Setup Location
• Leave enough clearance in front of the rack to enable you to open the front door
completely (~25 inches).
• Leave approximately 30 inches of clearance in the back of the rack to allow for
sufficient airflow and ease in servicing.
• This product is for installation only in a Restricted Access Location (dedicated
equipment rooms, service closets and similar environments).
Comments to this Manuals