5-111
Chapter 5: Web Based Management Utility
LoopBack Basic Settings
Clicking the LOOPBACK SETTINGS tab brings up the LOOPBACK BASIC SETTINGS page
(Figure 5-94), which allows you to configure loopback IP interfaces. The parameters for
this page are shown in Table 5-71.
Figure 5-94. LoopBack Basic Settings Page
Table 5-71. LoopBack Basic Settings Page Parameters
Parameter Description
LoopBack Interface This parameter is the name of the loopback interface getting created.
Interface Type This parameter is always the loopback for this configuration.
Interface Status This parameter for the I
NTERFACE STATUS can be set to Up or Down.
IP Address This parameter specifies the IP address for this loopback interface.
Subnet Mask This parameter specifies the subnet mask for this loopback interface.
Comments to this Manuals