1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User’s Manual
5-178
Candidate RPs
Clicking the CANDIDATE RPS tab brings up the CANDIDATE RP CONFIGURATION page
(Figure 5-157). The parameters for this page are shown in Table 5-128.
Figure 5-157. Candidate RP Configuration Page
Table 5-128. Candidate RP Configuration Page Parameters
Parameter Description
Component ID This parameter specifies a number uniquely identifying the component.
Group Address
This parameter represents the multicast group, for which the switch advertises
itself as the candidate RP.
Group Mask
This parameter specifies the subnet mask, which when combined with the group
address gives the group prefix.
RP Address This parameter represents the IP address of the Candidate-RP.
Comments to this Manuals