Supermicro SSE-X24S User Manual download pdf (Page 297)

A-3

Appendix A: Rack Installation

• Please comply with the regulations set up by your local hazardous waste

management agency to dispose of your used battery properly.

Rack Mounting Considerations

Ambient Operating Temperature

If installed in a closed or multi-unit rack assembly, the ambient operating temperature of

the rack environment may be greater than the ambient temperature of the room.

Therefore, consideration should be given to installing the equipment in an environment

compatible with the manufacturer’s maximum rated ambient temperature (Tmra).

Reduced Airflow

Equipment should be mounted into a rack so that a hazardous condition does not arise

due to uneven mechanical loading.

Mechanical Loading

Equipment should be mounted into a rack so that a hazardous condition does not arise

due to uneven mechanical loading.

Circuit Overloading

Consideration should be given to the connection of the equipment to the power supply

circuitry and the effect that any possible overloading of circuits might have on

overcurrent protection and power supply wiring. Appropriate consideration of equipment

nameplate ratings should be used when addressing this concern.

Reliable Ground

A reliable ground (earth) must be maintained at all times. To ensure this, the rack itself

should be grounded. Particular attention should be given to power supply connections

other than the direct connections to the branch circuit (i.e. the use of power strips, etc.).

A-5 Rack Mounting Instructions

This chapter provides information on installing the switch into a rack unit with the

CSE-PT52L rail kit. There are a variety of rack units on the market, which may mean the

assembly procedure will differ slightly. You should also refer to the installation

instructions that came with the rack unit you are using.

NOTE: This rail will fit a rack between 26" and 33.5" deep.

1 2 ... 292 293 294 295 296 297 298 299 300 301 302 ... 305 306

No comments

Supermicro SSE-X24S User Manual Page 297