Supermicro 6016GT-TF User Manual download pdf (Page 85)

Chapter 7: BIOS

7-15

as its I/O port address and IRQ 4 for the interrupt address. The options for Serial

Port1 are Disabled, 3F8/IRQ4, 3E8/IRQ4, 2E8/IRQ3. The options for Serial Port2

are Disabled, 2F8/IRQ3, 3E8/IRQ4, and 2E8/IRQ3.

XRemote Access Conﬁ guration

Remote Access

This allows the user to enable the Remote Access feature. The options are Disabled

and Enabled.

If Remote Access is set to Enabled, the following items will display:

Serial Port Number

This feature allows the user decide which serial port to be used for Console Redi-

rection. The options are COM 1 and COM 2.

Serial Port Mode

This feature allows the user to set the serial port mode for Console Redirection.

The options are 115200 8, n 1; 57600 8, n, 1; 38400 8, n, 1; 19200 8, n, 1; and

9600 8, n, 1.

Flow Control

This feature allows the user to set the ﬂ ow control for Console Redirection. The

options are None, Hardware, and Software.

Redirection After BIOS POST

Select Disabled to turn off Console Redirection after Power-On Self-Test (POST).

Select Always to keep Console Redirection active all the time after POST. (Note:

This setting may not be supported by some operating systems.) Select Boot Loader

to keep Console Redirection active during POST and Boot Loader. The options

are Disabled, Boot Loader, and Always.

Terminal Type

This feature allows the user to select the target terminal type for Console Redirec-

tion. The options are ANSI, VT100, and VT-UTF8.

VT-UTF8 Combo Key Support

A terminal keyboard deﬁ nition that provides a way to send commands from a remote

console. Available options are Enabled and Disabled.

Sredir Memory Display Delay

This feature deﬁ nes the length of time in seconds to display memory information.

The options are No Delay, Delay 1 Sec, Delay 2 Sec, and Delay 4 Sec.

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 105 106

No comments

Supermicro 6016GT-TF User Manual Page 85