Supermicro 6016GT-TF User Manual download pdf (Page 42)

5-8

SUPERSERVER 6016XT-TF/6016GT-TF/TF-TM2/TF-TC2 User's Manual

Memory Support

The X8DTG-DF supports up to 192 GB of registered ECC or up to 48 GB of unbuf-

fered ECC/non-ECC DDR3-1333/1066/800 MHz SDRAM in 12 DIMM slots. See the

following table for memory installation.

Notes: With unbuffered ECC/non-ECC memory, 2 GB is the maximum DIMM size

that can be supported per slot.

Memory speed support is dependent on the type of CPU used on the board.

Installing Memory Modules

Insert the desired number of DIMMs into the memory slots, starting with 1.

P1-DIMM 1A. For best memory performance, please install memory modules

of the same type and same speed on the memory slots as indicated on the

tables below.

Insert each DIMM module vertically into its slot. Pay attention to the notch 2.

along the bottom of the module to avoid installing incorrectly (see Figure 5-4).

Gently press down on the DIMM module until it snaps into place in the slot. 3.

Repeat for all modules.

CAUTION! Exercise extreme care when installing or removing DIMM

modules to prevent any possible damage.

5-6 Installing Memory

To Install: Insert module

vertically and press

down until it snaps into

place. Pay attention to

the alignment notch at

the bottom.

To Remove:

Use your thumbs to

gently push the release

tabs near both ends of

the module. This should

release it from the slot.

Figure 5-3. DIMM Installation

Top View of DDR3 Slot

Release Tab

Note: Notch should align

with the receptive key

point on the slot.

Notch

Front View

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 105 106

No comments

Supermicro 6016GT-TF User Manual Page 42