Supermicro SuperServer 6018R-WTR User Manual download pdf (Page 55)

Chapter 5: Advanced Serverboard Setup

5-5

1. There are two levers on the

LGA2011 socket. First press and

release the load lever labeled

'Open 1st'.

Installing an LGA 2011 Processor

5-4 Installing the Processor and Heatsink

Caution: When handling the processor package, avoid placing direct pressure on

the label area of the fan.

Notes:

• Always connect the power cord last and always remove it before adding,

removing or changing any hardware components. Make sure that you install the

processor into the CPU socket before you install the CPU heatsink.

• If you buy a CPU separately, make sure that you use an Intel-certiﬁ ed multi-

directional heatsink only.

• Make sure to install the serverboard into the chassis before you install the CPU

heatsinks.

• When receiving a serverboard without a processor pre-installed, make sure that

the plastic CPU socket cap is in place and none of the socket pins are bent;

otherwise, contact your retailer immediately.

• Refer to the Supermicro web site for updates on CPU support.

OPEN 1st

OPEN

WARNING!

OPEN 1st

WARNING!

Press down on

the lever labeled

'Close 1st'

Pull lever away

from the socket

2. Press the second load lever

labeled 'Close 1st' to release the

load plate from its locked position.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 125 126

No comments

Supermicro SuperServer 6018R-WTR User Manual Page 55