Supermicro 6016T-NTRF4+ User Manual download pdf (Page 52)

5-20

SUPERSERVER 6016T-URF4+/6016T-NTRF4+ User's Manual

LAN1/2/3/4 (Ethernet Ports)

Four Ethernet ports (designated LAN1,

LAN2, LAN3 and LAN4) are located

beside the VGA port on the I/O back-

plane. A dedicated IPMI LAN port is

also located above USB1. These ports

accept RJ45 type cables.

UID Buttons

There are two Unit Identiﬁ cation (UID)

buttons on the serverboard. The Front

Panel UID Switch connects to pin 13

of JF1. The Rear UID Switch (SW1) is

located next to LAN2. Pushing the UID

switch on the Front Control Panel will

illuminate both the Rear UID and the

Control Panel UID indicators. Push

the either switch again to turn off

both indicators. These UID indicators

provide easy identiﬁ cation of a system

that may be in need of service.

DOM Power Connector

A power connector for SATA DOM

(Disk_On_Module) Devices is located

at JWF1. Connect the appropriate

cable here to provide power support

for your DOM devices.

DOM PWR

Pin Deﬁ nitions

Pin# Deﬁ nition

1 +5V

2 Ground

3 Ground

External BMC I

C Connectors

Two external BMC (Baseboard Man-

agement Controller) SMBus Power

C) connectors are located at JIP-

MB2 and IPMB1. Both JIPMB2 and

IPMB1 are located on the same I

bus, providing the same support.

Connect one or both connectors for

External BMC I

C support.

BMC I

C (JIPMB2)

Pin Deﬁ nitions

Pin# Deﬁ nition

C Data

2 Ground

C CLK

BMC I

C (IPMB1)

Pin Deﬁ nitions

Pin# Deﬁ nition

C Data

2 Ground

C CLK

4NC

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 105 106

Comments to this Manuals

No comments

Supermicro 6016T-NTRF4+ User Manual Page 52

Comments to this Manuals

Related products and manuals for Server barebones Supermicro 6016T-NTRF4+