Supermicro 6016T-NTRF4+ User Manual download pdf (Page 34)

5-2

SUPERSERVER 6016T-URF4+/6016T-NTRF4+ User's Manual

5-2 Processor and Heatsink Installation

IMPORTANT! Always connect the power cord last and remove it ﬁ rst before add-

ing, removing or changing any hardware components. Make sure that you install

the processor into the CPU socket before you install the heatsink and fan. The

X8DTU-LN4F+ can support either one or two processors. If installing one proces-

sor only, install it into the CPU1 socket.

Note:

When purchasing a CPU or when receiving a serverboard with a CPU pre-installed,

make sure that the CPU plastic cap is in place and none of the CPU pins are bent;

otherwise, contact the retailer immediately.

When handling the processor, avoid placing direct pressure on the label

area of the fan. Also, do not place the serverboard on a conductive

surface, which can damage the BIOS battery and prevent the system

from booting up.

Starting with CPU1, press the 1.

socket clip to release the load

plate, which covers the CPU

socket, from its locked position.

Gently lift the socket clip to open 2.

the load plate.

Hold the plastic cap at its north 3.

and south center edges to remove

it from the CPU socket.

Note: The photos on this page and

succeeding pages are for illustration

purposes only. They do not necessarily

reﬂ ect the exact product(s) described

in this manual.

Socket Clip Load Plate

Plastic Cap

Holding the north & south edges

Installing LGA1366 Processors

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 105 106

No comments

Supermicro 6016T-NTRF4+ User Manual Page 34