Supermicro 6016T-NTRF4+ User Manual download pdf (Page 24)

2-10

SUPERSERVER 6016T-URF4+/6016T-NTRF4+ User's Manual

2-6 Checking the Drive Bay Setup

Next, you should check to make sure the peripheral drives and the hard drives and

backplane have been properly installed and all connections have been made.

Checking the Drives

All drives are accessable from the front of the server. The hard disk drives 1.

can be installed and removed from the front of the chassis without removing

the top chassis cover.

A slim DVD-ROM drive should be preinstalled in your server. For servicing 2.

the DVD-ROM drive, you will need to remove the top chassis cover. Refer to

Chapter 6 if you need to reinstall a DVD-ROM drive to the system.

Depending upon your system's conﬁ guration, your system may have one or 3.

more drives already installed. If you need to install hard drives, please refer to

Chapter 6.

Checking the Airﬂ ow

Airﬂ ow is provided by ﬁ ve sets of 4-cm fans (each set of fans consists of 1.

two fans that are mounted back to back). The system component layout was

carefully designed to direct sufﬁ cient cooling airﬂ ow to the components that

generate the most heat.

Note that all power and data cables have been routed in such a way that they 2.

do not block the airﬂ ow generated by the fans.

Providing Power

The last thing you must do is to provide input power to the system. Plug the 1.

power cord from the power supply module into a high-quality power strip that

offers protection from electrical noise and power surges.

It is recommended that you use an uninterruptible power supply (UPS) 2.

source.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 105 106

No comments

Supermicro 6016T-NTRF4+ User Manual Page 24