Supermicro X10DRH-I User Manual download pdf (Page 70)

3-4

X10DRH-C/CT/i/iT Motherboard User’s Manual

settings in the IPMI to make sure that the CPU and system temperatures are

within the normal range. Also check the front panel Overheat LED and make

sure that it is not on.

5. Adequate power supply: Make sure that the power supply provides adequate

power to the system. Make sure that all power connectors are connected.

Please refer to our website for more information on the minimum power

requirements.

6. Proper software support: Make sure that the correct drivers are used.

B. If the system becomes unstable before or during OS installation, check

the following:

1. Source of installation: Make sure that the devices used for installation are

working properly, including boot devices such as CD/DVD and CD/DVD-ROM.

2. Cable connection: Check to make sure that all cables are connected and

working properly.

3. Using the minimum conguration for troubleshooting: Remove all unnecessary

components (starting with add-on cards rst), and use the minimum congura-

tion (but with a CPU and a memory module installed) to identify the trouble

areas. Refer to the steps listed in Section A above for proper troubleshooting

procedures.

4. Identifying bad components by isolating them: If necessary, remove a compo-

nent in question from the chassis, and test it in isolation to make sure that it

works properly. Replace a bad component with a good one.

5. Check and change one component at a time instead of changing several

items at the same time. This will help isolate and identify the problem.

6. To nd out if a component is good, swap this component with a new one to

see if the system will work properly. If so, then the old component is bad.

You can also install the component in question in another system. If the new

system works, the component is good and the old system has problems.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 130 131

No comments

Supermicro X10DRH-I User Manual Page 70