Supermicro X10DRH-I User Manual download pdf (Page 100)

4-26

X10DRH-C/CT/i/iT Motherboard User’s Manual

Port 0~ Port 5

Select Enabled to enable a SATA port specied by the user. The options are

Disabled and Enabled.

Spin Up Device

On an edge detect from 0 to 1, set this item to allow the PCH to start a COMRE-

SET initialization to the device. The options are Enabled and Disabled.

SATA Device Type

Use this item to specify if the SATA port specied by the user should be con-

nected to a Solid State drive or a Hard Disk Drive. The options are Hard Disk

Drive and Solid State Drive.



sSATA Conguration

When this submenu is selected, AMI BIOS automatically detects the presence of

the SATA devices that are supported by the PCH-sSATA controller and displays

the following items:

sSATA Controller

This item enables or disables the onboard SATA controller supported by the Intel

PCH-sSATA controller. The options are Enabled and Disabled.

Congure sSATA as

Select IDE to congure an sSATA drive specied by the user as an IDE drive. Select

AHCI to congure an sSATA drive specied by the user as an AHCI drive. Select

RAID to congure an sSATA drive specied by the user as a RAID drive. The op-

tions are IDE, AHCI, and RAID.

*If the item above "Congure sSATA as" is set to AHCI, the following items will

display:

Support Aggressive Link Power Management

When this item is set to Enabled, the SATA AHCI controller manages the power

usage of the SATA link. The controller will put the link to a low power state when

the I/O is inactive for an extended period of time, and the power state will return

to normal when the I/O becomes active. The options are Enabled and Disabled.

sSATA Port 0~ Port 3

This item displays the information detected on the installed on the sSATA port.

specied by the user.

•Model number of drive and capacity

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 130 131

No comments

Supermicro X10DRH-I User Manual Page 100