Supermicro H8SCM-F User Manual download pdf (Page 38)

H8SCM(-F) Serverboard User's Manual

2-18

2-10 IDE and SATA Drive Connections

Use the following information to connect the IDE hard disk drive cables.

A red mark on a wire typically designates the location of pin 1.•

The 80-wire ATA133/100/66 IDE hard disk drive cable that came with your sys-•

tem has two connectors to support two drives. This special cable should be used

to take advantage of the speed this new technology offers. The blue connector

connects to the onboard IDE connector interface and the other connector(s) to

your hard drive(s). Consult the documentation that came with your disk drive for

details on actual jumper locations and settings for the hard disk drive.

IDE Drive Connector

Pin Deﬁ nitions (IDE#1)

Pin# Deﬁ nition Pin # Deﬁ nition

1 Reset IDE 2 Ground

3 Host Data 7 4 Host Data 8

5 Host Data 6 6 Host Data 9

7 Host Data 5 8 Host Data 10

9 Host Data 4 10 Host Data 11

11 Host Data 3 12 Host Data 12

13 Host Data 2 14 Host Data 13

15 Host Data 1 16 Host Data 14

17 Host Data 0 18 Host Data 15

19 Ground 20 Key

21 DRQ3 22 Ground

23 I/O Write 24 Ground

25 I/O Read 26 Ground

27 IOCHRDY 28 BALE

29 DACK3 30 Ground

31 IRQ14 32 IOCS16

33 Addr1 34 Ground

35 Addr0 36 Addr2

37 Chip Select 0 38 Chip Select 1

39 Activity 40 Ground

SATA Ports

There are no jumpers to conﬁ gure the SATA

ports, which are designated SATA0 through

SATA5. See the table on the right for pin

deﬁ nitions.

SATA Ports Pin Deﬁ nitions

(SATA0-SATA5)

Pin # Deﬁ nition Pin # Deﬁ nition

1 Ground 5 RXN

2 TXP 6 RXP

3 TXN 7 Ground

4 Ground

IDE Connector

There is one IDE connector on the

serverboard. See the table on the right for

pin deﬁ nitions.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 71 72

Comments to this Manuals

No comments

Supermicro H8SCM-F User Manual Page 38

Comments to this Manuals

Related products and manuals for Server/workstation motherboards Supermicro H8SCM-F