Supermicro H8SCM-F User Manual download pdf (Page 25)

Chapter 2: Installation

2-5

Gently press down on the memory module until it snaps into place.3.

Note: 1 GB, 2 GB, 4 GB, 8 GB and 16 GB memory modules are supported. It

is highly recommended that you remove the power cord from the system before

installing or changing memory modules. Please refer to our web site for memory

that has been tested on the H8SCM(-F) serverboard.

Memory Support

The H8SCM(-F) serverboard supports single and dual channel, DDR3-1333/1066/800

registered ECC/Unbuffered ECC/non-ECC SDRAM. Only interleaved memory is

supported, so you must populate two DIMM slots at a time, one per channel (see

procedure above).

Populating two adjacent slots at a time with memory modules of the same size and

type will result in interleaved (128-bit) memory, which is faster than non-interleaved

(64-bit) memory.

Maximum Memory

The H8SCM(-F) serverboard supports up to

16GB of ECC/Non-ECC UDIMM or up to 64GB of ECC RDIMM in 4 DIMM

slots.

Figure 2-1. Installing DIMM into Slot

To Install: Insert

module vertically and

press down until it

snaps into place. Pay

attention to the align-

ment notch at the

bottom.

To Remove: Use

your thumbs to gen-

tly push the release

tabs near both ends

of the module. This

should release it from

the slot.

Top View of DDR3 Slot

Release Tab Release Tab

Note: Notch should align with

the receptive key point on

the slot.

Notch

Front View

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 71 72

No comments

Supermicro H8SCM-F User Manual Page 25