Supermicro X6DVL-EG2 User Manual download pdf (Page 67)

Chapter 4: AMI BIOS

4-15

XRemote Access Configuration

You can use this screen to select options for the Remote Access Configu-

ration. Use the up and down <Arrow> keys to select an item. Use the

<Plus> and <Minus> keys to change the value of the selected option.

Remote Access

This feature allows the user to disable the function of Remote Access. If

Disabled is not selected, then you can select a Remote Access type. The

options are Enabled or Disabled.

XUSB Configuration

USB Function

This feature allows you to enable USB Host Controllers. The options are

Disabled and Enabled.

Legacy USB Support

Select Enabled to enable the support for USB Legacy. Disable legacy

support if there are no USB devices installed in the system. The options

are Disabled, Enabled and Auto.

USB 2.0 Controller

This setting allows you to enable or disable USB 2.0 Controller. The options

are Disabled or Enabled.

USB 2.0 Controller Mode

This setting allows you to configure USB 2.0 Controller Mode. The

options are Hi-Speed (480 Mbps) or Full Speed-12Mbps.

USB Mass Storage Device Configurations

USB Mass Storage Reset Delay

This setting allows you to decide how long the system shall wait in an

attempt to detect the presence of a USB Mass Storage Device before it

issues a start command to proceed with the next operation during POST.

The options are 10 Seconds, 20 Seconds, 30 Seconds and 40 Seconds.

Emulation Type

If set to Auto, USB devices that are smaller than 530MB will be emulated

as floppy, while remaining as a HDD. Forced FDD option will allow you to

configure a HDD formatted drive to boot as a FDD (Eg. Zip Drive). The

options are: Auto, Floppy, Forced FDD, Hard Disk, and CD ROM.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 105 106

No comments

Supermicro X6DVL-EG2 User Manual Page 67