Supermicro X6DVL-EG2 User Manual download pdf (Page 61)

Chapter 4: AMI BIOS

4-9

XPCI/PnP Configuration

This feature allows the user to set PCI/PnP configurations for the following

items:

Plug & Play OS

Select Yes to allow the OS to configure Plug & Play devices. (*This is not

required for system boot if you system has an OS that supports Plug &

Play.) Select No to allow the AMIBIOS to configure all devices in the sys-

tem.

PCI Latency Timer

This option sets the latency of all PCI devices on the PCI bus. Select 32 to

set the PCI latency to 32 PCI clock cycles. Select 64 to set the PCI latency

to 64 PCI clock cycles. Select 96 to set the PCI latency to 96 PCI clock

cycles. Select 128 to set the PCI latency to 128 PCI clock cycles. Select 160

to set the PCI latency to 160 PCI clock cycles. Select 192 to set the PCI

latency to 192 PCI clock cycles. Select 224 to set the PCI latency to 224 PCI

clock cycles. Select 248 to set the PCI latency to 248 PCI clock cycles.

Allocate IRQ to PCI VGA

Set this value to allow or prevent the system from assigning an interrupt

address to the VGA adapter card. The options are Yes and No.

Palette Snooping

Select Enabled to inform the PCI devices that an ISA graphics device is

installed in the system so that the graphics card can function properly. The

options are Enabled or Disabled.

PCI IDE BusMaster

Set this value to allow or prevent the use of PCI IDE busmastering. Select

Enabled to allow the AMI BIOS to use PCI busmaster for reading and writing

to IDE drives. The options are Disabled and Enabled.

Offboard PCI/ISA IDE Card

This option allows the user to assign a PCI slot number to an Off-board PCI/

ISA IDE card in order for it to function properly. The options are: Auto, PCI

Slot1, PCI Slot2, PCI Slot3, PCI Slot4, PCI Slot5, and PCI Slot6.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 105 106

No comments

Supermicro X6DVL-EG2 User Manual Page 61