Supermicro X9DB3-F User Manual download pdf (Page 88)

4-16

X9DB3-F/X9DBi-F/X9DB3-TPF/X9DBi-TPF Motherboard User’s Manual

Port 0~5 Staggered Spin Up

Select Enabled to enable Staggered Spin-up support to prevent excessive

power consumption caused by multiple HDDs spinning-up simultaneously.

The options are Enabled and Disabled.

RAID Mode

The following items are displayed when RAID Mode is selected:

Port 0~5 Hot Plug

Select Enabled to enable hot-plug support for the particular port. The options

are Enabled and Disabled.

SCU(StorageControlUnit)Conguration

Storage Controller Unit

Select Enabled to enable PCH SCU storage devices. The options are Disabled

and Enabled.

SCU RAID Option ROM/UEFI Driver

Select Enabled to support the onboard SCU Option ROM or UEFI Driver to boot up

the system via a storage device. The options are Disabled and Enabled.

SCU Port 0~SCU Port 7: The AMI BIOS will automatically detect the onboard SCU

devices and display the status of each SCU device as detected.

Note: iF boards only support SATA drives. 3F boards support both SATA

and SAS drives

PCIe/PCI/PnPConguration

Launch Storage OpROM Policy

This feature selects the Storage Option ROM to be used to bootup the system

when there are multiple Storage Option ROMs available. The options are UEFI

Only and Legacy Only.

PCI Latency Timer

Use this feature to set the latency timer for each PCI device installed on a PCI bus.

Select 64 to set the PCI latency to 64 PCI clock cycles. The options are 32, 64, 96,

128, 160, 192, 224 and 248.

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 112 113

No comments

Supermicro X9DB3-F User Manual Page 88