Supermicro X10SRL-F User Manual download pdf (Page 90)

4-18

X10SRL-F User’s Manual

Port 0~ Port 5

Select Enabled to enable a SATA port specied by the user. The options are

Disabled and Enabled.

Port 0 ~ Port 5 Spin Up Device

On an edge detect from 0 to 1, set this item to allow the PCH to start a COMRE-

SET initialization to the device. The options are Enabled and Disabled.

Port 0 ~ Port 5 SATA Device Type

Use this item to specify if the SATA port specied by the user should be con-

nected to a Solid State drive or a Hard Disk Drive. The options are Hard Disk

Drive and Solid State Drive.



sSATA Conguration

When this submenu is selected, the AMI BIOS automatically detects the presence

of the SATA devices that are supported by the SCU controller and displays the

following items:

sSATA Controller

This item enables or disables the onboard SATA controller supported by the Intel

SCU chip. The options are Enabled and Disabled.

Congure sSATA as

Select IDE to congure an sSATA drive specied by the user as an IDE drive. Select

AHCI to congure an sSATA drive specied by the user as an AHCI drive. Select

RAID to congure an sSATA drive specied by the user as a RAID drive. The op-

tions are IDE, AHCI, and RAID.

*If the item above "Congure sSATA as" is set to AHCI, the following items

will display:

Support Aggressive Link Power Management

When this item is set to Enabled, the sSATA AHCI controller manages the power

usage of the sSATA link. The controller will put the link in a low power mode

during extended periods of I/O inactivity, and will return the link to an active state

when I/O activity resumes. The options are Enabled and Disabled.

sSATA Port 0~ Port 3

This item displays the information detected on the installed sSATA drives on the

particular sSATA port.

•Model number of drive and capacity

•Software Preserve Support

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 128 129

No comments

Supermicro X10SRL-F User Manual Page 90