Supermicro X9DRW-7TPF+ User Manual download pdf (Page 29)

Chapter 2: Installation

2-5

OPEN 1st

WARNING!

2-3 Processor and Heatsink Installation

Warning: When handling the processor package, avoid placing direct pressure on

the label area.

Notes:

•Always connect the power cord last, and always remove it before adding,

removing or changing any hardware components. Make sure that you install

the processor into the CPU socket before you install the CPU heatsink.

•If you buy a CPU separately, make sure that you use an Intel-certied multi-

directional heatsink only.

•Make sure to install the system board into the chassis before you install

the CPU heatsink.

•When receiving a system board without a processor pre-installed, make sure

that the plastic CPU socket cap is in place, and none of the socket pins are

bent; otherwise, contact your retailer immediately.

•When you have one CPU, be sure to install the CPU in Socket 1 rst.

•Refer to the Supermicro website for CPU support and updates.

Press down on

the

load lever

labeled 'Open 1st'.

Installing the LGA2011 Processor

1. There are two load levers on the LGA2011 socket. To open the socket cover,

rst press and release the load lever labeled 'Open 1st'.

OPEN 1st

WARNING!

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 118 119

No comments

Supermicro X9DRW-7TPF+ User Manual Page 29