Supermicro SYS-8016B-6F User Manual download pdf (Page 40)

5-8

SUPERSERVER 8016B-6F/8016B-TF User's Manual

Memory Support

The X8QB6-F/X8QBE-F supports up to 512 GB of registered ECC DDR3-

1066/978/667 of memory in 32 DIMM slots. Please use memory modules of the

same type, speed, timing and same on a serverboard.

Note: See the table belows for memory installation.

Installing Memory Modules

Insert the desired number of DIMMs into the memory slots, starting with P1-1.

DIMM #A1.

Insert each DIMM module vertically into its slot. Pay attention to the notch 2.

along the bottom of the module to avoid installing incorrectly (see Figure 5-4).

Gently press down on the DIMM module until it snaps into place in the slot. 3.

Make sure that the side notches of the DIMM modules align with the lock/

release tabs of the slot when pressed in. Repeat for all modules.

Reverse the steps above to remove the DIMM modules from the serverboard.4.

CAUTION! Exercise extreme care when installing or removing DIMM

modules to prevent any possible damage.

5-6 Installing Memory

Lock/Release Tabs

Notches

Release

Processors and their Corresponding Memory Modules

CPU# Corresponding DIMM Modules

CPU 1 P1-1A P1-2A P1-3A P1-4A P1-5A P1-6A P1-7A P1-8A

CPU2 P2-1A P2-2A P2-3A P2-4A P2-5A P2-6A P2-7A P2-8A

CPU3 P3-1A P3-2A P3-3A P3-4A P3-5A P3-6A P3-7A P3-8A

CPU4 P4-1A P4-2A P4-3A P4-4A P4-5A P4-6A P4-7A P4-8A

Figure 5-3. Installing DIMMs

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 105 106

No comments

Supermicro SYS-8016B-6F User Manual Page 40