Supermicro P4SC8 User Manual download pdf (Page 22)

2-4

SUPER P4SC8/P4SCi User's Manual

2-4 Installing DDR Memory

CAUTION

Exercise extreme care when installing or removing memory

modules to prevent any possible damage.

Memory Module Installation (See Figure 2-2)

1. Insert each DDR memory module vertically into its slot. Pay attention to

the notch along the bottom of the module to prevent inserting the mod-

ule incorrectly. (See support information and the note below.)

2. Gently press down on the memory module until it snaps into place.

2-3 Mounting the Motherboard in the Chassis

All motherboards have standard mounting holes to fit different types of

chassis. Make sure that the locations of all the mounting holes for both the

motherboard and the chassis match. Although a chassis may have both

plastic and metal mounting fasteners, metal ones are highly recommended

because they ground the motherboard to the chassis. Make sure that the

metal standoffs click in or are screwed in tightly. Then use a screwdriver to

secure the motherboard onto the motherboard tray.

Lever

(*With Processor Installed)

Figure 2-1. 478-pin mPGA Socket: Empty and with Processor Installed

Pin 1

Support

The P4SC8/P4SCi supports Dual channel, ECC or non-ECC, unbuffered

DDR-400/333/266 SDRAM. *Populate DIMM0A,DIMM1A and/or DIMM0B,

DIMM1B with memory modules of the same size/same type will result in

the dual channel, two-way interleaved memory which is faster than the

single channel memory.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 93 94

No comments

Supermicro P4SC8 User Manual Page 22