Supermicro X9DRH-ITF User Manual download pdf (Page 29)

Chapter 2: Installation

2-5

OPEN 1st

WARNING!

2-3 Processor and Heatsink Installation

Warning: When handling the processor package, avoid placing direct pressure on

the label area.

Notes:

1. Always connect the power cord last, and always remove it before adding,

removing or changing any hardware components. Make sure that you in-

stall the processor into the CPU socket before you install the CPU heatsink.

2. Make sure that the processor wattage (TDP) does not exceed the maxi-

mum rating for the motherboard. Additionally, check that the TDP is within

the rating limits of the heatsink and chassis to ensure proper cooling and

operation. Refer to the chassis manual for more information.

3. If you buy a CPU separately, make sure that you use an Intel-certied

multi-directional heatsink only.

4. Make sure to install the system board into the chassis before you install

the CPU heatsink.

4. When receiving a system board without a processor pre-installed, make

sure that the plastic CPU socket cap is in place, and none of the socket

pins are bent; otherwise, contact your retailer immediately.

5. When you have one CPU, be sure to install the CPU in Socket 1 rst.

6. Refer to the Supermicro website for CPU support and updates.

Press down

Load Lever

labeled 'Open 1st'.

Installing the LGA2011 Processor

1. There are two load levers on the LGA2011 socket. To open the socket cover,

rst press and release the load lever labeled 'Open 1st'.

OPEN 1st

WARNING!

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 110 111

No comments

Supermicro X9DRH-ITF User Manual Page 29