Supermicro X10SRi-F User Manual download pdf (Page 92)

4-22

X10SRi-F User’s Manual

•Software Preserve Support

sSATA Port 0~ Port 3

Select Enabled to enable an sSATA port specied by the user. The options are

Disabled and Enabled.

sSATA Port 0 ~ Port 3 Hot Plug

This feature designates the sSATA port specied for hot plugging. Set this item

to Enabled for hot-plugging support, which will allow the user to replace an

sSATA disk drive without shutting down the system. The options are Enabled

and Disabled.

sSATA Port 0 ~ Port 3 Spin Up Device

On an edge detect from 0 to 1, set this item to allow the PCH to start a COMRE-

SET initialization to the device. The options are Enabled and Disabled.

Port 0 ~ Port 3 sSATA Device Type

Use this item to specify if the sSATA port specied by the user should be con-

nected to a Solid State drive or a Hard Disk Drive. The options are Hard Disk

Drive and Solid State Drive.

*If the item above "Congure sSATA as" is set to IDE, the following items

will display:

sSATA Port 0~ Port 3

This item indicates that an sSATA port specied by the user is not installed or

not detected.

Port 0 ~ Port 3 sSATA Device Type (Available when a SATA port is

detected)

Use this item to specify if the sSATA port specied by the user should be con-

nected to a Solid State drive or a Hard Disk Drive. The options are Hard Disk

Drive and Solid State Drive.

*If the item above "Congure sSATA as" is set to RAID, the following items

will display:

Support Aggressive Link Power Management

When this item is set to Enabled, the SATA AHCI controller manages the power

usage of the SATA link. The controller will put the link in a low power mode during

extended periods of I/O inactivity, and will return the link to an active state when

I/O activity resumes. The options are Enabled and Disabled.

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 130 131

No comments

Supermicro X10SRi-F User Manual Page 92