Supermicro SBA-7142G-T4 User Manual download pdf (Page 60)

SBA-7142G-T4 Blade Module User’s Manual

5-8

Super IO Device Configuration

The menu options in the SUPER IO CONFIGURATION submenu and their descriptions are

shown in Table 5-6.

Remote Access Configuration

The menu options in the REMOTE ACCESS CONFIGURATION submenu and their

descriptions are shown in Table 5-7.

Table 5-6. Super IO Configuration Submenu

Menu Option Description

Serial Port1 Address

This option specifies the base I/O port address and Interrupt Request address of

serial port 1. The options are D

ISABLED, 3F8/IRQ4, 3E8/IRQ4 and 2E8/IRQ3.

• Select D

ISABLED to prevent the serial port from accessing any system

resources. When this option is set to D

ISABLED, the serial port physically

becomes unavailable.

• Select 3F8/IRQ4 to allow the serial port to use 3F8 as its I/O port address

and IRQ 4 for the interrupt address.

Serial Port2 Address

This option specifies the base I/O port address and Interrupt Request address of

serial port 2. The options are D

ISABLED, 2F8/IRQ3, 3E8/IRQ4 and 2E8/IRQ3.

Select D

ISABLED to prevent the serial port from accessing any system resources.

When this option is set to D

ISABLED, the serial port physically becomes

unavailable.

Select 2F8/IRQ3 to allow the serial port to use 2F8 as its I/O port address and

IRQ 3 for the interrupt address.

Table 5-7. Remote Access Configuration Submenu

Menu Option Description

Remote Access

Allows you to Enable or Disable remote access. If enabled, the settings below

will appear.

Serial Port Number

Selects the serial port to use for console redirection. Options are COM1 and

COM2*

Serial Port Mode

Selects the serial port settings to use. Options are (115200 8, n, 1), (57600 8,

1), (38400 8,

N, 1), (19200 8, N, 1) AND (09600 8, N, 1).

Flow Control

Selects the flow control to be used for console redirection. Options are NONE,

Hardware and S

OFTWARE.

Redirection After

BIOS POST

Options are D

ISABLE (no redirection after BIOS POST), BOOT LOADER

(redirection during POST and during boot loader) and Always (redirection

always active). Note that some OS's may not work with this set to Always.

Terminal Type Selects the type of the target terminal: ANSI, VT100 and VT-UTF8.

VT-UTF8 Combo Key

Support

Allows you to Enable or D

ISABLE VT-UTF8 combination key support for ANSI/

VT100 terminals.

Sredir Memory

Display Delay

Use this setting to set the delay in seconds to display memory information.

Options are No Delay, 1

SEC, 2 SECS and 4 SECS.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 79 80

Comments to this Manuals

No comments

Supermicro SBA-7142G-T4 User Manual Page 60

Comments to this Manuals