Supermicro SuperServer 5037C-i User Manual download pdf (Page 52)

6-2

SUPERSERVER 5037C-i User's Manual

6-2 Front Control Panel

The front control panel must be connected to the JF1 connector on the motherboard

to provide you with system status and alarm indications. A ribbon cable has bundled

these wires together to simplify this connection. Connect the cable from JF1 on the

motherboard (making sure the red wire plugs into pin 1) to the appropriate comn-

nector on the front control panel PCB (printed circuit board). Pull all excess cabling

over to the control panel side of the chassis.

The LEDs inform you of system status - see Figure 6-1 for details. See Chapter 5

for details on JF1.

Figure 6-1. Front Control Panel LEDs

NIC

HDD

Overheat

Power On

Indicates network activity the GLAN port.

Indicates SATA hard disk/CD-ROM drive activity.

Indicates an overheat condition or fan failure.

Indicates the system is powered on.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 87 88

No comments

Supermicro SuperServer 5037C-i User Manual Page 52