Supermicro X8DTL-I User Manual download pdf (Page 20)

1-12

X8DTL-3/X8DTL-i/X8DTL-3F/X8DTL-iF User's Manual

WOL capability. In addition, an onboard LAN controller can also support WOL

without any connection to the WOL header. The 3-pin WOL header is to be used

with a LAN add-on card only.

Note: Wake-On-LAN requires an ATX 2.01 (or above) compliant power

supply.

1-7 Power Supply

As with all computer products, a stable power source is necessary for proper and

reliable operation. It is even more important for processors that have high CPU

clock rates.

The X8DTL-3/X8DTL-i/X8DTL-3F/X8DTL-iF can accommodate 24-pin ATX power

supplies. Although most power supplies generally meet the speciﬁ cations required

by the CPU, some are inadequate. In addition, the two 12V 8-pin power connections

are also required to ensure adequate power supply to the system. Also your power

supply must supply 1.5A for the Ethernet ports.

Warning: To prevent damage to the power supply or motherboard, please

use a power supply that contains a 24-pin and two 8-pin power connectors.

Be sure to connect these connectors to the 24-pin (JPW1) and the two

8-pin (JPW2,JPW3) power connectors on the motherboard for adequate

power supply to your system. Failure in doing so will void the manufacturer

warranty on your power supply and motherboard.

It is strongly recommended that you use a high quality power supply that meets ATX

power supply Speciﬁ cation 2.02 or above. It must also be SSI compliant (For more

information, please refer to the web site at http://www.ssiforum.org/). Additionally, in

areas where noisy power transmission is present, you may choose to install a line

ﬁ lter to shield the computer from noise. It is recommended that you also install a

power surge protector to help avoid problems caused by power surges.

1-8 Super I/O

The Super I/O supports 360 K, 720 K, 1.2 M, 1.44 M or 2.88 M disk drives and data

transfer rates of 250 Kb/s, 500 Kb/s or 1 Mb/s. It also provides two high-speed,

16550 compatible serial communication ports (UARTs). Each UART includes a

16-byte send/receive FIFO, a programmable baud rate generator, complete modem

control capability and a processor interrupt system. Both UARTs provide legacy

speed with baud rate of up to 115.2 Kbps as well as an advanced speed with baud

rates of 250 K, 500 K, or 1 Mb/s, which support higher speed modems.

The Super I/O provides functions that comply with ACPI (Advanced Conﬁ guration

and Power Interface), which includes support of legacy and ACPI power manage-

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 100 101

No comments

Supermicro X8DTL-I User Manual Page 20