Supermicro H8SGL-F User Manual download pdf (Page 60)

4-10

H8SGL(-F) Serverboard User’s Manual

 Remote Access Conﬁ guration

Remote Access

Use this option to Enable or Disable Remote Access in your system. If enabled,

the settings below will appear.

Serial Port Number

Use this setting to select the serial port for console redirection. Options include

COM1, COM2*. The displayed base address and IRQ for the serial port changes

to reﬂ ect the selection you make.

Note: Make sure the selected port is enabled.

Serial Port Mode

Selects the serial port settings to use. Options are (115200 8, n, 1), (57600 8,

n, 1), (38400 8, n, 1), (19200 8, n, 1) and (09600 8, n, 1).

Flow Control

Selects the ﬂ ow control to be used for console redirection. Options are None,

Hardware and Software.

Redirection After BIOS POST

Options are Disable (no redirection after BIOS POST), Boot Loader (redirection

during POST and during boot loader) and Always (redirection always active).

Note that some OS's may not work with this set to Always.

Terminal Type

Selects the type of the target terminal. Options are ANSI, VT100 and VT-

UTF8.

VT-UTF8 Combo Key Support

Allows you to Enable or Disable VT-UTF8 combination key support for ANSI/

VT100 terminals.

Sredir Memory Display Delay

Use this setting to set the delay in seconds to display memory information.

Options are No Delay, 1 sec, 2 secs and 4 secs.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 73 74

No comments

Supermicro H8SGL-F User Manual Page 60