Supermicro H8DMU+ User Manual download pdf (Page 62)

4-12

H8DMU+ User’s Manual

 USB Mass Storage Device Conﬁ guration

This submenu allows you to configure USB mass storage class

devices.

USB Mass Storage Reset Delay

This setting allows you to specify the number of seconds POST

waits for the USB mass storage device after the Start Unit

command. Options are 10, 20, 30 or 40 seconds.

Emulation Type

If Auto, USB devices less than 530 MB will be emulated as ﬂ oppy

drives and the rest as hard drives. The forced Floppy option can be

used to force a hard disk formatted drive to boot as the ﬂ oppy drive.

Options are Auto, Floppy, Forced FDD, Hard Disk and CDROM.

 Hyper Transport Conﬁ guration

NODE0:NODE1 HT Link Speed

This setting speciﬁ es the speed the Hyper Transport link will run if it is

slower than or equal to the system clock and the board is capable of

doing so. Options are Auto, 200 MHz, 400 MHz, 600 MHz, 800 MHz

and 1 GHz.

NODE0:NODE1 HT Link Width

This setting speciﬁ es the width the Hyper Transport link will run. Options

are Auto, 4-bit, 8-bit and 16-bit.

MCP55 (SB) to K8 (CPU) Freq. Auto

This setting is to enable or disable frequency selection by CPU

capability. Options are Enabled and Disabled.

MCP55 (SB) to K8 (CPU) Frequency

This setting is used to set the frequency used. Options are 200 MHz,

400 MHz, 600 MHz, 800 MHz, 1000 MHz, 1200 MHz, 1400 MHz and

1600 MHz.

MCP55 (SB) to K8 (CPU) LinkWidth

This setting is used to select the link width. Options are 4 4, 8 8

and 16 16.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 79 80

No comments

Supermicro H8DMU+ User Manual Page 62