Supermicro C7Q67-O User Manual download pdf (Page 63)

3-5

Chapter 3: Troubleshooting

Question: Why do I get an error message “IASTOR.SYS read error” and "press F6

to install Intel RAID driver" when installing Windows on my motherboard?

Answer: To solve this issue, disable the IPMI jumper. Another solution is to use a

USB oppy drive instead of the onboard oppy drive. For the IPMI jumper location,

please check Chapter 1.

Question: What is the heatsink part number for my C7Q67 motherboard?

Answer: For the 1U passive heatsink, ask for SNK-P0046P (back plate is included).

For the 2U active heatsink, use SNK-P0046A4.

Question: Why can't I recover the BIOS even when I’ve followed the instructions

in the user’s manual for the motherboard?

Answer: Please disable the IPMI jumper and try it again. For the jumper location,

please check Chapter 1.

3-4 Battery Removal and Installation

Battery Removal

To remove the onboard battery, follow the steps below:

Power off your system and unplug your power cable.1.

Locate the onboard battery as shown below.2.

Using a tool such as a pen or a small screwdriver, push the battery lock out-3.

wards to unlock it. Once unlocked, the battery will pop out from the holder.

Remove the battery.4.

Battery

Lock

Battery

Proper Battery Disposal

Warning! Please handle used batteries carefully. Do not damage the bat-

tery in any way; a damaged battery may release hazardous materials into

the environment. Do not discard a used battery in the garbage or a public

landll. Please comply with the regulations set up by your local hazardous

waste management agency to dispose of your used battery properly.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 94 95

No comments

Supermicro C7Q67-O User Manual Page 63