Supermicro CSE-742T-550 B Datasheet

Browse online or download Datasheet for Computer cases Supermicro CSE-742T-550 B. Supermicro CSE742T 550B User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 5
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
SC742 Chassis Instructions
The special design of the SC742 chassis allows it to either be used as a tower or as a rackmount
system. There are several versions of the chassis, which differ primarily in the power supply and
IDE/SCSI configuration. Please refer to the following instructions when working on the SC742.
I. Removing the Chassis Side Cover:
You will need to remove the chassis side cover to
:
A. Remove or install drives into any of the 5 ¼” drive bays.
B. Replace chassis fans.
C. Access the motherboard.
Procedure
:
1. Remove the two screws from the back lip of the side cover (this is the left cover when
looking from the front).
2. Push in the release tab on the cover and push the cover back to the rear of the chassis. It
should stop after moving about ½ inch.
Release Tab
Depress tab
while pushing
cover toward
rear of chassis.
3. You can now lift the side cover up and off the chassis.
Page view 0
1 2 3 4 5

Summary of Contents

Page 1 - SC742 Chassis Instructions

SC742 Chassis Instructions The special design of the SC742 chassis allows it to either be used as a tower or as a rackmount system. There are severa

Page 2

A. Removing/Installing Drives into the 5 ¼” Drive Bays: Procedure: 1. With the side chassis cover removed, you have access to the 5 ¼” drive bays.

Page 3

B. Removing/Installing Chassis Fans into the 5 ¼” Drive Bays: Procedure: 1. To remove the hot-swap chassis fans, grasp the fan handle while squeezing

Page 4

II. Removing the Front Chassis Cover: You do not need to remove the front bezel to access the drives: Procedure 1. Push on the three tabs on the insi

Page 5

III. Removing the Top Chassis Cover and Chassis Feet to Install as Rackmount: You will need to remove the top chassis cover to add rack rails to the c

Comments to this Manuals

No comments