Supermicro X7DWA-N User Manual Page 27

  • Download
  • Add to my manuals
  • Print
  • Page
    / 95
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 26
Chapter 2: Installation
2-7
SUPER X7DWA-N
®
DDR2 FBD DIMM
To Install: Insert module vertically and press down until it
snaps into place. Pay attention to the alignment notch at
the bottom.
Installing and Removing DIMMs
To Remove:
Use your thumbs
to gently push
the release tabs
near both ends of
the module. This
should release it
from the slot.
Top View of DDR2 FBD Slot
Possible System Memory Allocation & Availability
System Device Size Physical Memory
Remaining (-Available)
(4 GB Total System Memory)
Firmware Hub ash memory (System BIOS) 1 MB 3.99
Local APIC 4 KB 3.99
Area Reserved for the chipset 2 MB 3.99
I/O APIC (4 Kbytes) 4 KB 3.99
PCI Enumeration Area 1 256 MB 3.76
PCI Express (256 MB) 256 MB 3.51
PCI Enumeration Area 2 (if needed) -Aligned on
256-MB boundary-
512 MB 3.01
VGA Memory 16 MB 2.85
TSEG 1 MB 2.84
Memory available to OS and other applications 2.84
Note 2: DDR2 FBD 800 MHz memory is supported by the processors with FSB
1333 MHz and 1066 MHz; however, it will run @667 MHz.
Note 3: Due to the OS limitations, some operating systems may not show more
than 4 GB of memory.
Note 4: Due to memory allocation to system devices, memory remaining avail-
able for operational use will be reduced when 4 GB of RAM is used. The reduction
in memory availability is disproportional. Refer to the Memory Availability Table
below for details.
Page view 26
1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 94 95

Comments to this Manuals

No comments