Supermicro SuperChassis 510T-203B User Manual download pdf (Page 29)

4-13

Chapter 4: Chassis Setup and Maintenance

The SC510T chassis has one 200 Watt power supply. This power supply is auto-

switching capable. This enables it to automatically sense and operate at a 100v to

240v input voltage. In the unlikely event that the power supply unit fails, the system

will shut down and you will need to change the power supply unit.

New units can be ordered directly from Supermicro (see contact information in the

Preface).

Replacing the Power Supply

Power Supply Replacement

Unplug all power leading to the chassis. 1.

Disconnect all wiring from the power supply.2.

Remove the four screws which hold the power supply in the chassis. The 3.

two front mounting screws are located on the front of the power supply. The

two rear mounting screws are accessed on the underside of the chassis and

extend upwards through the mounting thru holes, to hold the power supply in

place. Set the screws aside for later use.

4-8 Power Supply

Figure 4-14: Installing the Power Supply

Power Supply

Mounting Thru Holes

Front Mounting Screws

Rear Mounting Screws

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 47 48

No comments

Supermicro SuperChassis 510T-203B User Manual Page 29